TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 0, 4096 bytes) pci_bus 0000:00: busn_res: end is updated to 00 pci 0000:00:00.0: invalid calibration data pci_bus 0000:00: No busn resource found for root bus, will use ar71xx: using random MAC address for eth1 ar71xx: using random MAC address for eth0 registering PCI controller with io_map_base unset Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) PID hash table entries: 256 (order: -2, 1024 bytes) Kernel command line: board=TL-WDR3500 console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd Built 1 zonelists in Zone order, mobility grouping on. Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.

Initrd not found or empty - disabling initrd MyLoader: sysp=dfcff7ff, boardp=ffffffff, parts=ffdfdbff Exposing the serial port is only useful if you plan to custom firmware (i.e., OpenWrt on it) and do some hacking.Option path 'pci0000:00/0000:00:00.0' 都是零。。。。。。。。。。 This instructable is aimed for electronics and robotics enthusiasts. * Reasonable soldering skills and good eyes! * A fine tipped soldering iron, solder, and a solder wick. * A couple of strands of insulated wire-wrap wire and a heavier duty wire. I’ve decided to elaborate and show you how to do this properly. In essence, you just need to solder a couple of wires to some pads onto its PCB. What follows is a simple hack to add a serial port to your WR703N device. * With a little work, it has a serial port. * Cheap and easy to buy ($20 USD from eBay). It is an extremely compact wireless router that ticks all the boxes: The TL-WR703N is a handy bit of electronics for a hacker to have.

Port serial tplink 941n